Measurement Computing Analyzer488 - Manual (Page 83)

Section 3 Front Panel Operation
3.37
Record memory location of the first available recorded bus event.
The first location can be
EMPTY or from 0 to 32,767.
Last 00000
Record memory location of the last available recorded bus event.
The last location can be
EMPTY or be from 0 to 32767.
[DISPLAY] The Display function [SHIFT][STAT], is used to adjust the
brightness of the front panel alphanumeric display and to set the
scroll rate of help messages. A data input menu prompts for input.
Use the [
↑] and [↓] cursor keys to vary the display brightness and
scroll rate. Leave the menu with [ENTER] or [EXIT] and cancel
with [ESC].
Display Intensity 32
Requests a display intensity. Intensity can be from 1 to 60.
Help Scroll Speed 6
Request a scroll speed for help messages. Scroll speed can be from 1
to 10.
[SETUP] The Setup key, [SETUP], is used to configure one or more
triggering parameters used in recording bus events. See also [ARM]
and [MEASURE]. [SETUP] uses menus to input setup parameters.
Use the cursor keys to step between configuration parameters. The
configuration session is ended by pressing [ENTER] to set every
parameter or pressing [EXIT] when the parameters of interest have
been changed. The operation may be aborted by pressing [ESC]. If
[SETUP]
is pressed during power-up, it is used to configure the
Analyzer488 operating mode, serial port parameters and IEEE 488
bus address of the Analyzer488. Refer to paragraph 3.4 for
configuration details.
Match? Nul XXXXXXX
(hex)