Measurement Computing Analyzer488 - Manual (Page 161)

Section 4 Serial Controller
4.67
SEND
The SEND command is used when the Analyzer488 is in the High Level
Controller Mode to send low level bus sequences. SEND provides byte-by-byte control
of data and control transfers on the bus and can specify exactly which operations will
be executed by the Analyzer488.
This command does not have a query option.
TYPE High Level Controller command
SYNTAX SEND [;] sub-command[sub-command…]
RESPONSE None or device data
REMARKS The following sub-commands are available within the SEND
command:
UNT Send the multiline Untalk command. ATN is asserted.
UNL Send the multiline Unlisten command. ATN is asserted.
MTA Send My Talk Address (Analyzer488). ATN is asserted.
MLA Send My Listen Address (Analyzer488). ATN is asserted.
TALK addr
Send Talk Address addr device (TAG). ATN is asserted.
LISTEN addr[,addr…]
Send Listen Addresses (LAG). ATN is asserted.
DATA {'data'|char[,char…]}
Send character strings, data, or characters with numeric
ASCII values, char. ATN is unasserted.