Measurement Computing Analyzer488 - Manual (Page 59)

Section 3 Front Panel Operation
3.13
3.7.3 Recording Bus Events
Use the same keyboard controller program to record a test
sequence of events on the bus.
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
Press [ERASE][ENTER] :
Erase Memory? Yes
to erase record memory
Press [FAST] FAST LED lights
to set bus handshaking to fast.
Press [REC] REC and RECORD LED lights
to start recording
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
00000 SCG20 74
¼ ¼
CMD> output 00;test
00008 ACG13 0D
¼ ¼
This display means that eight events were recorded. The controller
asserted Attention after the "test" message and ACG13 is the bus
message for the multiline command &h0D (ASCII CR).
Press [REC] REC and RECORD LED off
to turn recording off
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
BUS ACG13 OD
¼ ¼
This display shows that the Analyzer488 is again in the bus display
mode, &h0D is on the bus, and the Attention and Remote Enable bus
management lines are asserted.