Measurement Computing Analyzer488 - Manual (Page 20)

Section 1 Introduction
1.8
1.5 Inspection
The Analyzer488 was carefully inspected, both mechanically and electrically,
prior to shipment. When you receive the Analyzer488, carefully unpack all items
from the shipping carton and check for any obvious signs of physical damage which
may have occurred during shipment. Immediately report any such damage to the
shipping agent. Remember to retain all shipping materials in the event that shipment
back to the factory becomes necessary.
Every Analyzer488 is shipped with the following:
• Analyzer488 IEEE 488 Bus Analyzer
• Analyzer488 -901 Instruction Manual
• CA-47 Serial Cable
• Analyst488 Analyst Software for the IBM PC
• Analyzer488-311 Function Key Templates
• Analyzer488-900 Quick Reference Card
• Power Supply 5 Volt Regulated
TR-9; 115V or
TR-9E; 220V
When the Analyzer488 is powered-on, it performs various hardware tests and
displays the results on the front panel display. If the Analyzer488 detects a hardware
failure during these tests, a message will appear on the display showing the failure.
The three failure messages that may be displayed are shown below:
Analyzer RAM Error
The Analyzer488 has detected an error while testing system RAM. No further
operation will occur.
Analyzer ROM Error
The Analyzer488 has detected an error while testing system ROM. No further
operation will occur.