Measurement Computing Analyzer488 - Manual (Page 208)

Section 5 Analyst488 Software
5.20
5.10.6 Block Find Next
This command is used to search for the next data item that was
specified while using the Block Find command. Data can be found in either
the Analyzer Window or the File Window.
This command may also be selected without pulling down the Search
Menu by pressing .
5.10.7 Compare Blocks
The Compare Blocks command allows you to compare a marked
block in one window with a marked block in another window. The
comparison stops on the first discrepancy and the cursor is positioned to
that spot in the active window. This command is useful for comparing a
previously recorded event sequence to a current one.
5.10.8 Goto Address
When this command is selected, a dialog box will appear prompting
for a location. The cursor is then moved to the specified location in the
active window.
This command may also be selected without pulling down the Search
menu by pressing .
5.10.9 Goto Offset
This command moves the cursor in the active window to a location
relative to the current location. When this command is selected, a dialog
box will appear prompting for an offset (a number between -32,767 and
32,767). An effective location is computed which is equal to the present
location plus the offset. The cursor is then moved to the new location in the
active window.
This command may also be selected without pulling down the Search
menu by pressing .