Measurement Computing Analyzer488 - Manual (Page 15)

Section 1 Introduction
1.3
1.2.1 Typographic Conventions
This manual uses different typefaces to represent keys, commands,
displays, and various other elements important to using the Analyzer488.
The following typographical conventions are used in this manual:
[KEYS] Analyzer488 front panel keys are shown in square brackets.
Computer keys are shown in angle brackets
COMMANDS Command keywords are shown in this typeface.
Menus Menu selections are shown in boldface.
DISPLAYS Analyzer488 front panel displays are shown this way.
output Responses are shown like this.
ATN LED LED indicators are called out this way.
%00000000 Specifies Binary data
&H3F Specifies Hexadecimal data
122 Specifies decimal data
'A' Specifies ASCII data
1.2.2 Abbreviations
The following IEEE 488 abbreviations are used throughout this manual.
addr n IEEE bus address "n"
ACG Addressed Command Group
ACK Acknowledge
ATN Attention
BEL Bell
BS Backspace
CAN Cancel
CR Carriage Return
data Data String
DAV Data Valid bus handshaking line
DC1 Device Control 1
DC2 Device Control 2
DC3 Device Control 3
DC4 Device Control 4
DCL Device Clear
DIOn Bus data lines n = 1 to 8
DLE Data Link Escape
EM End of Medium