Measurement Computing Analyzer488 - Manual (Page 209)

Section 5 Analyst488 Software
5.21
5.10.10 Goto Reference
This command moves the cursor in the active window to the reference
location (relative location 0). The reference location is set by the Set
Reference command.
5.11 Handshake Menu
The handshake menu lets you change the handshaking speed of the Analyzer488.
It also lets you change the Talk and Listen states.
5.11.1 Listen
This command configures the Analyzer488 handshake circuitry to
perform an acceptor handshake and accept data from the bus. The
handshake speed may be set to Fast, Slow, Step, or None.
This command may also be selected without pulling down the
Handshake menu by pressing .
5.11.2 Talk
This command configures the Analyzer488 handshake circuitry to
perform a source handshake and place data on the bus. The handshake
speed may be set to Fast, Slow, Step, or None.
This command may also be selected without pulling down the
Handshake menu by pressing .
5.11.3 Fast
This command allows the Analyzer488 to participate in bus events
without limiting the event speed. The Fast handshake speed may not be
useful in viewing bus events because the display rate cannot keep up with a
fast bus event rate.