Measurement Computing Analyzer488 - Manual (Page 80)

Section 3 Front Panel Operation
3.34
last location written in the record memory during the most resent
recording operation. The record memory location, bus message, and
management line status are displayed on the front panel display.
[LAST]
is valid only when viewing record memory. If nothing was
recorded, a status message is displayed:
Not Available
[-TRIGGER] The Last Trigger command, [SHIFT][LAST], searches the record
memory for the previous trigger point. The record memory location,
bus message, and management line status are displayed on the front
panel display. [-TRIGGER] is valid only when viewing record
memory. A status message is displayed while searching:
+Searching...
If no trigger is found, a status message is displayed:
Trigger Not Found
[NEXT] The Next key, [NEXT], is used to search the record memory for the
next occurrence of an event specified using [FIND]. The
parameters specified for the Find command will be used in the
search. If the event is found, the record memory location containing
that event is displayed. [FIND] and [NEXT] operations will
search the entire record memory until the event is found. A status
message is displayed while searching:
+Searching...
If no match is found, a status message is displayed and the
previously displayed location is displayed again:
Pattern Not Found
[FIND] The Find menu, [SHIFT][NEXT], is used to search the record