Measurement Computing Analyzer488 - Manual (Page 195)

Section 5 Analyst488 Software
5.7
At the CMD> prompt, you may type any of the Serial Controller
commands listed below. If a particular command returns a response, the
response will be printed on the screen.
The following commands may be issued when using the Command
Line Controller window:
ADDRESS LOCAL LOCKOUT PPOLLU TRIGGER
ABORT OUTPUT REMOTE TERM
CLEAR PPOLL RESUME
ENTER PPOLLC SEND
LOCAL PPOLLD SPOLL
This command may also be selected without pulling down the File
menu by pressing .
For further information on the above commands and syntax, refer to
the Serial Controller section (Section 4) of this manual.
5.7.6 Mark Block
This command sets the present cursor position as the beginning of a
block of data in a window. The cursor keys may then be used to select the
size of the block to be marked. The marked block is displayed in reverse
video for easy identification.
This command is used to select a portion of the data in a window for
writing, printing, searching, or transferring. This command is also used to
remove the current block marker from the active window.
This command may also be selected without pulling down the File
menu by pressing .
5.7.7 Mark All
This command is used to mark an entire block of data in a window
for writing, printing, searching or transferring.
This command may also be selected without pulling down the File
menu by pressing .