Measurement Computing Analyzer488 - Manual (Page 27)

Section 2 Getting Started
2.5
[SHIFT][STEP]( which will select NONE).
Enter the same commands as before.
After issuing the commands, press [REC]to disable recording and then press
[VIEW] to view the record memory. To scroll through the record memory locations,
press [
↑] or [↓].
Refer to paragraph 3.7 for more examples of how to use the front panel of the
Analyzer488.
2.3 Configuration
Configuration of the Analyzer488 operating mode is accomplished at power-up.
The default operating mode and specific parameters for that mode, such as IEEE 488
bus and RS232 serial port parameters and terminators can be set. Once configuration
parameters are set, they become the power-on default values for the Analyzer488.
Pressing and holding the [SETUP] key while turning on the rear panel ON/OFF
switch invokes menus that use the front panel display and keyboard to set various
operating mode parameters. Use the [
↑] and [↓] keys to scroll through parameters
or use the [0] - [9] keys for numeric data. Press [ENTER] to select a parameter, press
[EXIT]
when parameters are set, or press [ESC] to abort the configuration session.
Pressing [EXIT] will use all parameters that have been selected using [ENTER] and
will leave the configuration menus with any remaining parameters unchanged.
The following menus are used for configuration. Press [ENTER] between
displays to advance to the next menu.
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
Press [ENTER]
Config Reset? No
to skip reset.
Press [ENTER]
Config Reset? Yes
to reset factory default parameters