5 command line controller – Measurement Computing Analyzer488 User Manual
Page 194
Section 5
Analyst488 Software
5.6
5.7.4.4 Character Data Entry
The state of the data lines may be set by entering any of the
printable characters from the keyboard while this field is active.
When this field is inactive, this position displays the state of
the data lines with Attention (ATN) unasserted, regardless of its
actual state.
5.7.4.5 Binary Data Entry
The individual data lines may be asserted or unasserted
from this field. Each data bit has a corresponding key on the
keyboard which toggles its current state. The data lines DIO8
through DIO1 are activated by keys , ,
,
5.7.4.6 Control Line Control
The individual control lines may be asserted or unasserted
from this field. Each data bit has a corresponding key on the
keyboard which toggles its current state. The control lines EOI,
ATN, SRQ, REN, and IFC are activated by keys ,
, and respectively.
5.7.4.7 Handshake Speed Control
This field allows the handshake speed of the Analyzer488 to
be set when this field is active. The keys 5.7.5 Command Line Controller The Command Line Controller command opens a window that allows you to directly issue a subset of the Analyzer488 Serial Controller, and
can be used to choose None, Fast, Slow, and Step respectively. In
addition, the
the handshake speeds.
Mode bus commands.