Measurement Computing Analyzer488 - Manual (Page 158)

Section 4 Serial Controller
4.64
REMOTE
The REMOTE command asserts the Remote Enable (REN) bus management line.
If optional bus addresses are specified, then REMOTE addresses those devices to listen,
placing them in the Remote Addressed state.
This command does not have a query option.
TYPE High Level Controller command
SYNTAX REMOTE [addr[,addr ...]]
addr is an IEEE 488 bus device address
RESPONSE None
MODE High Level Controller
BUS STATES REN (without addresses)
REN, ATN•UNL, MTA, LAG (with addresses)
QUERY None
RESPONSE
EXAMPLES PRINT #1,"REMOTE" Assert Remote Enable
PRINT #1,"REMOTE16,28" Assert Remote Enable and
address devices 16 and 28 to
listen.