Measurement Computing Analyzer488 - Manual (Page 18)

Section 1 Introduction
1.6
1.3 Specifications
IEEE 488-1978 Interface
Front Panel Mode: SH1, AH1, E1
Serial Controller
Mode:
SH1, AH1, E1 with C1, C2, C3, C4 and C28 controller
subsets
Instrument
Simulator Mode:
SH1, AH1, T6, TE0, L4, LE0, SR1, RL0, PP2,
DC1, DT1, E1.
Programmable terminators, waveforms, data format,
buffer data, display data, keypad response, parallel and
serial poll responses, service request and status.
Connectors: Standard IEEE 488 connector with metric studs. BNC
connector for trigger output. Card edge connector for
all IEEE 488 bus signals( unbuffered). DB9 RS-232
connector.
Handshake Speeds: Programmable Single Step, Slow (1 to 10
bytes/second), Fast (up to 1M byte/second) and None.
Capture Trigger: Bus Management and Data line programmable for low
(0), high (1) and don’t care (0 or 1). Programmable
pattern occurrence from 1 to 65,535, trigger delay from
1 to 99,999,999 bus events and post trigger capture
depth from 1 to 32767 transactions.
Serial Interface
EIA RS-232C: AB, BA, BB, CA, CB
Character Set: Asynchronous bit serial.
Serial I/O Buffers: 8,000 characters total, dynamically allocated.
Output Voltage: ±5 volts min (RS-232C)
Input Voltage: ±3 volts min.; ±15v max.
Baud Rate: Selectable 300, 600, 1200, 2400, 4800, 9600, and
19,200.
Data Format: Selectable 7 or 8 data bits; 1 or 2 stop bits; odd, even,
and no parity.
Duplex: Full with Echo/No Echo.