Measurement Computing Analyzer488 - Manual (Page 178)

Section 4 Serial Controller
4.84
TALK
The TALK command is used to allow the Analyzer488 to place data on the bus.
The TALK command can only be used in the Low Level Controller Mode
(CONTROLLER OFF).
The query command, TALK?, returns the current status of the Analyzer488.
TALK is returned if it is in Talk State, LISTEN is returned if it is in Listen State.
TYPE Low Level Controller command
SYNTAX TALK [?]
RESPONSE None
MODE Low Level Controller
BUS STATES None
QUERY TALK if in Talk State, LISTEN if in Listen State.
RESPONSE
EXAMPLES PRINT#1,"CONTROLLER OFF"
PRINT#1,"ASSERT REN ATN"
PRINT#1,"HANDSHAKE STEP"
PRINT#1,"TALK"
PRINT#1,"WRITE &H54"
Send TAG20 command