Measurement Computing Analyzer488 - Manual (Page 65)

Section 3 Front Panel Operation
3.19
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
LISTEN LED on
BUS NUL 00
Press [STEP][ATN]
BUS ACG00 00
¼
STEP and ATN LED on
[REN][TALK]
BUS ACG00 00
¼ ¼
TALK and REN LED on
to make the Analyzer488 the active controller
Press [IFC]
BUS IFC 00
¼ ¼¼
to clear the DMM bus interface
the IFC LED and front panel digit will flash
Press [3][0][ENTER]
BUS LAG16 30
¼ ¼
or [3][0][STEP]
to address the DMM to listen
The RMT and LSN LEDs on the DMM will light
(Note that pressing either [ENTER] or [STEP] will
perform a handshake when STEP handshaking is
selected.)
SRQ IFC
REN ATN
EOI LOCATION MESSAGE
Press [ATN]
BUS '0' 30
¼
to release the Attention line
Press [4][6][ENTER]
BUS 'F' 46
¼
to send 'F'
Press [3][0][ENTER]
BUS '0' 30
¼
to send '0'
Press [5][2][ENTER]
BUS 'R' 52
¼
to send 'R'