Measurement Computing Analyzer488 - Manual (Page 159)

Section 4 Serial Controller
4.65
RESET
The High Level Controller Mode command RESET provides a warm start of the
Analyzer488 interface. Issuing the RESET command clears the serial input (pending
commands) and output (pending data) buffers and reinitializes the internal IEEE
controller hardware. It is equivalent to issuing the following commands:
ABORT
DISARM
ERROR
OFF
LOCAL
TIME
OUT 10
The RESET command provides a warm start of the interface as well as clearing
all error conditions. Upon detection of the RESET command, the Analyzer488
unasserts its serial output handshake line (RTS). It reasserts RTS when it is capable of
accepting serial input data. If XON/XOFF handshake is selected, the handshake state is
not effected by the RESET command.
This command does not have a query option.
TYPE High Level Controller
SYNTAX RESET
RESPONSE None
MODE High Level Controller
BUS STATES IFC,*IFC,*REN
QUERY None
RESPONSE
EXAMPLE PRINT#1,"RESET"