Gasboy CFN III Config Mnl V3.4 - Manual (Page 90)

Console Configuration
Page 84 MDE-4316C CFN Series CFN III Configuration Manual for Windows NT® · April 2007
24 Allow pump down fuel entry: Should the entry of fuel-sale amounts be allowed when a
pump is down?
25 Require customer to confirm prepay price at pump: Are prepay customers required to
press CASH or CREDIT at the pump?
26 Preset zero quantity complete transactions: Should a restart of prepaid no- quantity fuel
transactions be allowed on the POS?
27 Disallow CASH ENTER tender sequence: Should the entry of a cash amount for cash tender
be required?
28 Tax food-stamp purchases: Are taxes charged on food-stamp purchases? (Profit Point only)
29 *Prevent item/dept auto-preset of fuel sale: If enabled, helps prevent merchandise from
being added to the wrong fuel sale because the PRESET key is required before you can add
merchandise to a pump with a completed current sale.
30 *Merchandise rings to merchandise sale: If enabled, merchandise will automatically be
rung up on a merchandise sale, then the clerk can move it to a fuel sale.
31 Drawer compulsion: If enabled, no further action can be taken at a Check Point/ Profit Point
until its open cash drawer has been closed.
32 Verification data (except PIN) at console keyboard or PIN pad: Will a clerk enter a
customer's verification data (such as odometer) at the POS keyboard, or will the customer
enter it on a PIN pad? (0 = PIN on PIN Pad; 1 = Everything except lookup on PIN Pad; 2
=Everything on POS keyboard). When setting 2 is used, and the PIN is entered from the
keyboard, the PIN cannot be encrypted. The message DES not ready will appear if you try to
get an encrypted PIN from the keyboard.
33 Check Point commands wait for log printer: When Site Controller commands are entered
from the Check Point/Profit Point, will the Check Point/Profit Point delay displaying the next
prompt until the log printer has finished printing the previous operation.
34 *Operator permission to reverse paid sales: The permission level a clerk needs in order to
reverse paid sales. If the perm level on reversals (spec func 6) is greater or equal to this, that
perm level will be required to reverse paid and unpaid sales. If this level is higher, this is the
level required for paid sales. The perm level for spec func 6 is required to reverse unpaid sales.
35 Pause POS sale if card is run: A pump that is already activated may be paused and the clerk
alerted when a card is inserted at a DPT. Default is No, enable by setting to Yes.
36 Warn operator if payable sale is too old (minutes, 0=no warning): A timer can be set that
warns a clerk if a sale remains payable without being modified for more than a configured
number of minutes (up to 30, +/-15 secs). This can be used to detect drive-aways and
accidental mistakes while keying-in that create a sale.