Gasboy CFN III Config Mnl V3.4 User Manual
Page 35
MDE-4316C CFN Series CFN III Configuration Manual for Windows NT® · April 2007
Page 29
Pump Configuration
• Slow-to-Cutoff: Sets the volume (in thousandths) where the slow-to-cutoff cuts in. This is
to prevent pre-pay and limit transactions from coasting past the shut-off point. The default
is 500 thousandths.
• Fill Units: Sets which unit (dollars, gallons, or liters) is used in the fill limit. The default is
dollars.
• Fill Amount: Sets how many dollars, gallons, or liters are authorized when a fill is
requested. The default is 50. This is overwritten by the LOAD CUTOFF command. It is
used only if the Pump table is reconstructed.
• Maximum Units: Sets which unit (dollars, gallons, or liters) is used in the maximum
amount. The default is gallons.
• Maximum Amount: Sets the maximum number of dollars, gallons, or liters allowed and
cannot be overwritten. Zero, which is the default, indicates an unlimited amount.
• Pulse Unit: Sets which unit-dollars, gallons, or liters-the pulser uses. The default is
dollars.
• Pulses per Unit: If the pump is mechanical, sets the number of pulses per dollar, gallon,
or liter used by the pump's pulser. The system counts transitions rather than pulses, and
since there are two transitions per pulse, you should enter twice the number of pulses per
unit. If a pulser for a pump sends 500 pulses per gallon, the figure to enter for that pump is
1000. If a pulser for a pump sends 1000 pulses per gallon, the figure to enter for that pump
is 2000. The default is 1000.
Note:Because of a National Weights and Measures requirement, the pulser rate can be
changed only when a special chip is set in the Site Controller. Contact your service
representative.
• Hoses: If the pump is a multi-product dispenser, specifies how many hoses the pump has.
The default is 4.
Figure 3-1: Example of Pump Configuration Using Submenu 1
# Pump Type C1 Slow Fill Max Pulse Hoses
1. Mechanical 1 0.500 10 0 500/G
2. Mechanical 1 0.500 10 0 500/G
3. Mechanical 1 0.500 10 0 500/G
4. Mechanical 1 0.500 10 0 500/G
5. Gasboy SPD Cash/Credit 1 0.500 $10 0 1000/$
6. Mechanical 1 0.500 $10 0 1000/$
7. Mechanical 1 0.500 10 0 500/G
8. Mechanical 1 0.500 10 0 500/G
9. Mechanical 1 0.500 10 0 500/G
10. Mechanical 1 0.500 10 0 500/G
11. Tokheim 162/262 1 0.500 $10 0 1000/$
12. Tokheim 162/262 1 0.500 $10 0 1000/$
13. Tokheim SA MMD Cash/Credit 1 0.500 $10 0 1000/$ 3
14. Tokheim SA MMD Cash/Credit 1 0.500 $10 0 1000/$ 3
15. Tokheim TCS Cash/Credit 1 0.500 $10 0 1000/$ 3
16. Tokheim TCS Cash/Credit 1 0.500 $10 0 1000/$ 3
17. Wayne Cash/Credit 1 0.500 $10 0 1000/$
18. Wayne Cash/Credit 1 0.500 $10 0 1000/$