Gasboy CFN III Config Mnl V3.4 - Manual (Page 28)

System Parameters
Page 22 MDE-4316C CFN Series CFN III Configuration Manual for Windows NT® · April 2007
112 Log remote port commands executed: Should commands sent to the Site Controller from
the remote port (for example, by a remote computer or terminal dialing in) be recorded on the
log printer? Default is no.
113 Unique shift #'s for every console: Allows the disk journal to track console shifts separately.
Default is no.
114 Hours required between NEXT SHIFT/DAY: How many hours from a NEXT SHIFT/DAY
command must pass before a subsequent NEXT SHIFT/DAY command will be carried out.
Default is 0.
115 Initial drawer value after NEXT SHIFT/DAY: The amount of cash in the drawer that each
shift or day will start with. The default is $300.
116 Buffered cumulative totalizers on RESET TOTALS: Preserves the cumulative totals at the
point where the RESET TOTALS command is run. This allows you to figure out the totals
(based on cumulative totalizers) for last shift/day without having to shut down the site. The
default is no.
117 Blank lines for page break: Number of blank lines to leave between pages on the log printer.
This allows you to skip perforations when using tractor-feed perforated paper in a dedicated
log printer. Default is 0. The range is 0-10.
118 Lines of text per page on direct printout: Lines of text per page on the log printer. Default is
66 lines (11 inches times 6 lines per inch); the range is 11-127 lines.
119 Logger initialization: This is how you send an initialization string to your log printer, if
required by the printer you are using.
120 Pre 4.1 SCI compatibility for odometer and manual #: Maintain compatibility with the
pre-version 4.1 Site Controller I for odometer and manually-entered vehicle number. Earlier
systems inserted zeros when no number was entered by the customer; the current system uses
spaces (blanks). Default is no (uses spaces).
Page 10: Tank Gauge
121 Log gauge delivery: Should deliveries detected by the tank gauge be recorded on the log
printer? The default is yes.
122 Transaction for gauge delivery: Should deliveries detected by the tank gauge generate
transactions? The default is no.
123 Add to tank inventory after gauge delivery: Should the amounts of deliveries detected by
the tank gauge be added to the tank inventory totals? The default is no.
124 Log fuel drop card: When the driver of a tanker uses his card to record a fuel drop at your
site, should this drop be added to the log, where it cannot be polled by a remote site? The
default is no.