Gasboy CFN III Config Mnl V3.4 - Manual (Page 79)

MDE-4316C CFN Series CFN III Configuration Manual for Windows NT® · April 2007 Page 73
Console Configuration
11 – Console Configuration
This chapter deals with the configuration of a Check Point console. If your site has a Profit
Point console, refer to the Profit Point manuals. Some of the Check Point parameters affect the
Profit Point; refer to
“How to Change POS Parameters” on page 81 later in this chapter.
The submenus in the Console program allow you to:
• Assign product numbers and actions to Check Point keys (submenu 1).
• Assign permission levels to Check Point actions (submenu 2).
• Set Check Point parameters (submenu 3).
Most sites will never use submenus 2, 4, or 5. Some sites will use submenu 1, and service
technicians might use submenu 3. Never make any changes to submenus 4 and 5 without first
consulting Gasboy.
How to Assign Products and Actions to Keys
Submenu 1 of the console configuration program allows you to assign any of the available
Check Point actions to any Check Point key, except the numeric keys on the numeric keypad.
Keys can have different actions depending on whether the keyswitch is turned to OFF, ON,
SUPERVISOR, or MANAGER.
For example, you could assign the keys that are usually the pump select keys to Site Controller
commands when the keyswitch is turned to MANAGER. If there are fewer than 16 pumps on
the Check Point, you can assign the extra pump keys to perform other actions-such as selecting
the merchandise sale or ringing up a merchandise product-when the keyswitch is turned to
ON.
Figure 11-1 on page 74 shows the numbers of the Check Point keys on a 71-key keyboard.