Comtech EF Data NetVue Release 1.1 User Guide - Manual (Page 245)

SNMP Managers Revision 3
NetVue User Guide MN-NETVUE
A–8
A.5.2 Changing the SNMP port used by a NetVue Agent
To cause NetVue to use another port:
1. Open the file:
C:\Skyline NetVue\NetVue.xml
2. Change the port specified in the SNMP tag.
In this example, NetVue uses port 461:
A.5.3 Identify which port NetVue is using
To find which port is in use, look in this file:
C:\Skyline NetVue\Logging\SNMPAgent.txt
If the default port is in use, then you will find text like this:
2010/08/09 10:33:52.070|SNMPAgent|6336|6664|SNMP Agent Port|DBG|1|
Local SNMP Port set to 161 (DEFAULT)
If a non-default port is in use, then you will find text like this:
2010/08/09 10:35:13.621|SNMPAgent|3288|3428|SNMP Agent Port|DBG|1|
Local SNMP Port set to 461 (OVERRULED)
A.6 Configuring SNMP agent community strings
You can configure the community strings used by the SNMP Agent of a DMA.
A.6.1 On a DMA level
1. Open C:\Skyline NetVue\NetVue.xml.
2. Specify the community strings in the SNMP tag:
A.6.2 On element level
1. Open C:\Skyline NetVue\Elements\[ElementName]\element.xml.
2. Specify the community strings in the SNMPAgent tag:
1