Compuprint 4247-Z03 Programmer Manual - Manual (Page 90)

Set Vertical Spacing 8 Lines/30mm (DC4 DC4 ESC 3 8)
14 14 1B 33 38
This command sets line spacing to 8 lines per 30 mm.
Eject Single Sheet or Form Feed (DC4 DC4 ESC 5)
14 14 1B 35
This command causes a form feed on fanfold forms.
Set 15, 17.1, 20 CPI (DC4 DC4 ESC A)
14 14 1B 41 NN
This command sets horizontal spacing (characters per inch) to 15, 17.1 or 20.
The values for NN are:
4
15 CPI
5 17.1 CPI
6 20 CPI
Load or Park Fanfold from a Rear Path (DC4 DC4 ESC N)
14 14 1B 4E NN
This command loads or performs the Park function for fanfold paper fed from the rear path.
The values for NN are:
0
The printer selects the rear path. If paper fanfold is already loaded in a paper path that is not
requested, the printer automatically performs the Park function before loading the rear path. The
printer will then load the fanfold paper once data is received. For more information on the Park
function, see “PARK/PATH” in “Chapter 2. Understanding the Operator Panel” in the User's Guide
for your printer.
1 The printer performs the Park function for forms in the rear path.
Load or Park Fanfold from a Front Path (DC4 DC4 ESC T)
14 14 1B 54 NN
This command loads or performs the Park function for fanfold paper fed from the front path.
The values for NN are:
0
The printer selects the front path. If paper fanfold is already loaded in a paper path that is not
requested, the printer automatically performs the Park function before loading the front path. The
printer will then load the fanfold paper once data is received. For more information on the Park
function, see “PARK/PATH” in “Chapter 2. Understanding the Operator Panel” in the User's Guide
for your printer.
1 The printer performs the Park function for forms in the front path.
70 Programmer Manual