Compuprint 4247-Z03 Programmer Manual - Manual (Page 226)

Note: In an LPD command, no Alternate Exception
Action occurs.
X'021202' Font Storage is Full
Explanation: There is insufficient pattern storage to
store the font transmitted with the Load Symbol Set
command.
There is insufficient storage to load the data transmitted
with the Load Font Equivalence command.
Alternate Exception Action: None.
X'021301' Invalid Absolute Move Baseline Value
Explanation: The Absolute Move Baseline parameter
value is not a valid or supported value.
Alternate Exception Action: None.
X'021401' Invalid Absolute Move Inline Value
Explanation: The Absolute Move Inline parameter
value is not a valid or supported value.
Alternate Exception Action: None.
X'021402' Font to be Deleted Not Found
Explanation: The single byte font specified by the
Deactivate Font command is not in the machine.
Alternate Exception Action: None.
X'021403'
Explanation: Unsupported Baseline Move
Alternate Exception Action: None.
X'021502' Invalid DF Font
Explanation: The Loaded Font Identifier field is
required in the Deactivate Font command; however, it is
not present or its value is not a valid or supported
value.
Alternate Exception Action: None.
X'021701' Invalid Variable Space Increment
Explanation: The value of the variable space
increment as specified in a text control is not a valid or
supported value.
Alternate Exception Action: None.
X'021702' Invalid DF Deletion Type
Explanation: The Deletion Type on a Deactivate Font
command is not a valid or supported value.
Alternate Exception Action: None.
X'021802' Invalid Font ID
Explanation:
1. The two-byte Font Identifier on a Load Symbol Set
or Load Font Equivalence command is not a valid or
supported value.
2. The one-byte Font Identifier value on the Load Font
Equivalence command is not a valid or supported
value.
3. A font is referenced on a Set Font control, a Logical
Page Description, a Load Symbol Set, a Write
Graphics, or Write Bar Code command, but the font
has not been previously identified by the Load Font
Equivalence command.
4. The font or symbol set referenced in a Logical Page
Description, Write Text, or Write Graphics command
is defined within the current Load Font Equivalence
but is not loaded in the printer.
Alternate Exception Action:
1. None.
2. None.
3. Substitute the active font for the specified local font
and continue processing.
4. Substitute the active coded font for the specified
local font and continue processing.
X'021901' Repeat String Length Error
Explanation: The Repeat String target string length is
not a valid or supported value.
Alternate Exception Action: None.
X'021902' Multiple Occurrences of the Same LFE
Local ID
Explanation: Explanation: The one-byte Local
Identifier value in the Load Font Equivalence command
has been used more than once, making the Two-Byte
Font Identifier reference ambiguous.
Alternate Exception Action: None.
X'021C01' Invalid Embedded Text Control
Sequence
Explanation: A text control sequence contains a code
other than X'D3' following X'2B'.
Alternate Exception Action: None.
X'021D02' Invalid LFE Identifier
Explanation: One or more of the following font
parameters listed in the LFE or their combination is not
valid or supported: Character Set ID, Code Page ID,
Uniform Character Increment, and Proportional
Increment Coefficient Table.
Alternate Exception Action: None.
206 Programmer Manual