Compuprint 4247-Z03 Programmer Manual - Manual (Page 126)

Decimal Hex Value Description
93-94 5D-5E 0006 Vector Length
95-96 5F-60 C3C6 Loaded Font Function Set Identifier
97-98 61-62 FF20 Symbol Sets
Bar Code Function Set Vector
Decimal Hex Value Description
99-100 63-64 000C Vector Length
101-102 65-66 C2C3 Bar Code Function Set Identifier
103-104 67-68 FF10 BC/1 Level Identifier
105-106 69-6A 1001 Unordered Bar Code Blocks Supported
107-108 6B-6C 4022 (see note
1)
4002 (see note
2) Limited Simulated Color and Color of Medium Supported (see
note 3)
109-110 6D-6E A0C0 0°, 90° Orientation Supported
Notes:
1. 4247 native mode.
2. 4224 and 4230 emulation mode.
3. For Limited Simulated Color support, all valid but unsupported color values for text data are accepted
and result in simulation of the specified colors without generation of unsupported color exceptions. In
the 4247 Printer, simulation of Color of Medium is done by printing in Color of Medium, except where
not possible because of different resolutions when text overlays graphics, image, or bar code. For
actual colors, all valid colors not listed in the above table are simulated in the 4247 Printer by printing
in black.
Set Home State (SHS)
Length D697 Flag Correlation ID (Optional)
This command is valid in any state. When the printer receives the Set Home State command, the current
page ends, all buffered data prints, and the printer returns to the home state. If the printer receives this
command while already in the home state, the printer treats this command as a No Operation command.
Acknowledge Reply (ACK)
Length D6FF 00 DATA
or
Length D6FF 40 Correlation ID DATA
The printer uses the Acknowledge Reply to return device status, sense information, and any additionally
requested information back to the host application program. The application program uses the
Acknowledge data to maintain control of the printing application and to begin error recovery actions when
necessary. The printer sends an acknowledgment:
v Whenever the acknowledgment required bit in the flag byte is on
106 Programmer Manual