Compuprint 4247-Z03 Programmer Manual - Manual (Page 207)

OCR-A OCR-B
MSI UPC - Two Digit Add-On (Magazine)
2 of 5 Industrial UPC - Five Digit Add-On (Paperback)
2 of 5 Matrix EAN-8
2 of 5 Interleaved EAN-13
Codabar EAN Two Digit Add-On
EAN Five Digit Add-On
5. Wide-to-Narrow ratio is only valid for the following bar code types:
v Code 3 of 9 (X'01')
v MSI (X'02')
v 2 of 5 Industrial (X'0A')
v 2 of 5 Matrix (X'0B')
v Interleaved 2 of 5 (X'0C')
v Codabar (X'0D')
The default ratio for Codabar, Code 3 of 9, and the 2 of 5 types is 2.5:1 for unit/module width of 0.36
and 0.43 mm (0.014 and 0.017 in.), 3:1 for 0.53 mm (0.021 in.), and 2.5:1 for 0.71 mm (0.028 in.) The
default for MSI is always 2:1.
6. BCDD bytes 12 and 15-1A and WBC command byte 0 are not applicable to POSTNET; these bytes
are ignored by the printer as the POSTNET Specification defines values for these parameters.
7. The 4247 Printer provides Limited Simulated Color Support. All architecturally defined color values for
graphics data are accepted and result in simulation of the specified colors without generation of
unsupported color exceptions. All valid colors not listed in the above table (X'0001' through X'0007',
X'0009' through X'0010', and X'FF01' through X'FF06') are simulated by printing in black.
8. If the color requested is not available, the printer uses black.
Figure 28 on page 188 shows the BCDD field specifying the size of the bar code medium presentation
space within the bar code block on the logical page. The bar code medium presentation space must fit
within the bar code block.
Chapter 4. IPDS Programming Information 187