Serial interface signals, Lan interface port, Led indicators – Compuprint 4247-Z03 Programmer Manual User Manual
Page 356: Usb interface port, Serial interface signals lan interface port
Serial Interface Signals
The following table lists the RS-232/C serial interface signals:
Signal Name
Pin Number
Local
Connect.
Source
Remote
Connect.
Source
Description
SIGNAL
GROUND
5
–
–
Always connected to the 0 Volts of the Power Supply
TXD
3
Printer
Printer
Transmitted Data Signal (an output from printer). A
MARK condition is held during IDLE communication
state. An indeterminate state is present when printer is
powered off.
RXD
2
Host
Data Set
Received data signal (an input to printer).
RTS
7
Printer
Printer
Request to Send Signal (an output from printer). Active
HIGH level signal. It is HIGH until the printer is
powered off, then an indeterminate state is present .
CTS
8
Data Set
Active HIGH level signal indicates that the host or data
set is ready to receive data from the printer.
DSR
6
Data Set
Active HIGH level signal. Indicates that the host or data
set is ready to be connected to the printer and is ready
for data transfer.
DCD
1
Data Set
Active HIGH level signal. Indicates that the host is
transmitting or the data set is receiving the Data Carrier
signal.
2nd RTS
9
Printer
Functionally equivalent to the DTR signal.
DTR
4
Printer
Printer
Data Terminal Ready. Normally HIGH (ON). Indicates
that the printer is ready to initiate a connection.
LAN Interface Port
LAN Interface Port
1. Ethernet 10/100BaseT Connector
2. Green 10/100Mbit/sec. Transmission Speed LED
3. Yellow Traffic LED
LED Indicators
The LED indicator modes are described in the following table:
LED
Status
Description
Yellow LED
Unlit
Transmission speed at 10Mbit/sec.
Lit
Transmission speed at 100Mbit/sec.
Green LED
Blinks
Transmitting or receiving packets from the network.
USB Interface Port
USB 2.0 full speed 12/Mbit/sec. interface.
336
Programmer Manual