Specification check-graphics - x'03 – Compuprint 4247-Z03 Programmer Manual User Manual
Page 222
Specification Check-Graphics - X'03'
The following exception codes are the valid codes for a graphics specification check condition:
X'030001'
Unallocated Graphic Order or
Command Code
Explanation:
1. An attempt was made to execute an unallocated
order code that is reserved for future use.
2. An attempt was made to execute an unallocated
command code that is reserved for future use.
Alternate Exception Action: None.
X'030002'
Reserved Byte Error or Invalid Default
Explanation:
1. A reserved byte in the graphic order is not set to
zero.
2. The Set Current Defaults instruction attempts, in
byte 2, to set an invalid or unsupported attribute.
3. An invalid default byte value was received in the
GDD.
Alternate Exception Action: None.
X'030003'
Incorrect Drawing Order Length
Explanation: A drawing order length is invalid.
Alternate Exception Action: None.
X'030004'
Invalid Attribute Value
Explanation: An attribute value for a graphic order or
for a WGC Set Current Default instruction is invalid.
Alternate Exception Action: Use the standard default
value for that attribute.
X'030008'
Truncated Order Error
Explanation: An order has been requested that is not
a complete order. This order is one of the following:
1. A fixed 2-byte order and the second byte is not in
the segment.
2. A long order and the length byte is not in the
segment.
3. A long order and the number of bytes following the
byte containing the length count to the end of the
segment is less than the value of the length count.
Alternate Exception Action: None.
X'03000C'
Segment Prologue Error
Explanation: A supported order that is not valid within
a prologue was found in a prologue.
The end of a segment was reached without an End
Prologue order.
Alternate Exception Action: None.
X'03000E'
Unsupported Attribute Value
Explanation: An attribute value for a graphic order or
for a WGC Set Current Default instruction is not
supported.
Alternate Exception Action: Use the standard default
value for that attribute.
X'0300021'
Invalid Default
Explanation: The Set Current Defaults instruction sets
an invalid or unsupported default for an attribute.
Alternate Exception Action: None.
X'033400'
Character Angle Value Not Supported
Explanation: The specific character angle requested
is not supported.
Alternate Exception Action: Use the closest angle
supported by the printer.
X'033E00'
Invalid End Prologue
Explanation: An End Prologue was found outside the
prologue section of a segment.
Alternate Exception Action: None.
X'036000'
Area Bracket Error
Explanation: An End Area order has been executed
without a Begin Area order having previously been
executed.
Alternate Exception Action: None.
X'038000'
Begin Area Received Incorrectly
Explanation: Begin Area order received while Begin
Area is already in progress.
Alternate Exception Action: None.
X'036801'
Area Truncation Error
Explanation: A Begin Area order has been executed
in a segment, and the end of the segment is reached
without an End Area order being executed. Area fill
implementation results are printer dependent.
Alternate Exception Action: None.
202
Programmer Manual