Compuprint 4247-Z03 Programmer Manual - Manual (Page 44)

HF LF Font and Pitch
00 0B Courier 10
01 EB Courier 12
01 EC Courier 15
01 ED Courier 17
01 EE Courier 20
00 AB Courier Proportional
HF LF Font and Pitch
00 24 Gothic 10
01 8F Gothic 12
01 8E Gothic 15
01 8D Gothic 17
01 8C Gothic 20
00 AE Gothic Proportional
Set Initial Conditions (SIC) (ESC [ K)
1B 5B 4B LL HH INIT ID P1 P2
This control initializes the printer.
A two-byte count (LL HH) indicates the number of bytes that follow in this control. LL is the least significant
byte of the count; HH is the most significant byte. (HH is always X'00' for this command.) The number of
bytes is counted from the INIT byte.
The INIT byte is processed the same way in 4247, 4202 III XL, or 2381 emulation mode, but causes
different results in the P1 and P2 parameters, depending on the ID byte. The values for the INIT byte are:
INIT Mode Byte
X'00'
Initializes printer to user-defined settings; downloaded fonts are not
initialized.
X'01' Initializes printer to user-defined settings; downloaded fonts are
initialized.
X'04' Initializes printer to factory settings; downloaded fonts are not
initialized. See Note.
X'05' Initializes printer to factory settings; downloaded fonts are initialized.
See Note.
X'FE' Initializes printer to user-defined settings; downloaded fonts are
initialized. Settings are saved in non-volatile memory (NVM).
X'FF' Initializes printer to factory settings; downloaded fonts are initialized.
See Note. Settings are saved in non-volatile memory (NVM).
ID Printer ID Byte:
X'B6'
For 4247 or 2381 emulation
X'03' or X'16' For 4202 III XL emulation
P1 Parameter Byte for 4247 or 2381 Emulation
X'00'
No Emulation Change
X'01' Switch to 2381 emulation
X'02' Switch to Epson FX printer emulation
X'03' to X'FF' No Emulation Change
24 Programmer Manual