Compuprint 4247-Z03 Programmer Manual - Manual (Page 81)

This control spaces backward in 1/120s of an inch. To find the values for N1 and N2, determine the
required displacement in 1/120s of an inch. Send the resulting number in the formula: N1 + (N2 X 256).
Set 15 CPI (ESC g)
1B 67
This control prints any data stored in the print buffer, and initializes following text to print at 15 CPI.
Feed Paper n/216 Reverse (ESC j)
1B 6A
This command causes fanfold paper to feed backwards n/216 of an inch.
Select NLQ Font (ESC k)
1B 6B NN
This control selects an NLQ font based on the following values of NN:
0
Courier
1 Gothic
This control affects only NLQ.
Set Left Margin (ESC l)
1B 6C NN
This control sets the left margin to NN columns from the left edge of the physical page to the beginning of
the print line. Where NN is a hex value. The number of inches in the margin does not vary if the font,
character width, or horizontal dot density changes. This command automatically clears and resets
horizontal tabs to every eight characters, then performs a cancel operation. The smallest possible space
between the left margins is the width of one double-wide, 10 CPI character. If a margin control code
violates this minimum distance, it is ignored. Settings in proportional mode are treated as 10 CPI.
Turn Proportional Mode On/Off (ESC p)
1B 70 NN
This control sets proportional mode on or off to the following values of NN:
0
Mode is Off
1 Mode is On
This control overrides condensed and is available for DP, NLQ, and user-defined characters.
Quiet Printing (ESC s)
1B 73 NN
Chapter 2. Epson FX-1050 Data Stream 61