Compuprint 4247-Z03 Programmer Manual - Manual (Page 71)

Select Graphics Mode (ESC *)
1B 2A MM N1 N2
This control selects the graphics mode MM from the table below. The total number of columns equals N1
+ (N2
×256).
Option
Alternate
Code
MM
Horizontal
Density
(dots/in.)
Single-Density ESC K 0 60
Double-Density ESC L 1 120
High-Speed Double-Density * ESC Y 2 120
Quadruple-Density * ESC Z 3 240
CRT I NONE 4 80
Plotter (1:1) NONE 5 72
CRT II NONE 6 90
Double-Density Plotter NONE 7 144
Note: (*) Adjacent dots cannot be printed in this mode
Auto Underscore (ESC –)
1B 2D NN
This control turns on and off the continuous underscore function.
If NN is an odd value (1, 3, 5 ...), the printer underscores all text characters and spaces following this
sequence. The printer does not underscore white space caused by horizontal tabs.
If NN is an even value (0,2,4,...), the printers stops the underscore of all data following this sequence.
Select Vertical Tab Channel (ESC /)
1B 2F CH
This control selects the vertical tab channel. The values for CH are 0 to 7. The channel selected by this
control is used for all subsequent vertical tab commands. Channel 0 is used if no channel has been
selected.
Set 1/8 Inch Line Spacing (ESC 0)
1B 30
This control sets the line spacing to eight lines per inch.
Chapter 2. Epson FX-1050 Data Stream 51