Compuprint 4247-Z03 Programmer Manual - Manual (Page 362)

HTTP Yes
PING Yes
SNMP Yes
MIB II (RFC 1514) Yes (see note)
Host Resource MIB (RFC 1514) Yes
Printer MIB (RFC1759) Yes
4247 Private MIB Yes
Reverse Telnet No
PROS No
IPP No
SLPv2 No
HARDWARE
RISC processor Yes
Flash memory 4MB
RAM 16MB
Attachment connector type RJ-45
Network traffic led Yes (green)
Network speed led Yes (yellow)
FIRMWARE UPGRADE
Firmware upgrade over network Yes
Firmware upgrade through parallel interface Yes
Note: All relevant parts of MIB-II (RFC1231) required to support HP JetAdmin are implemented.
v
- The following IP table group OIDs are not implemented: ipForwarding, ipDefaultTTL , ipInReceives
,ipInHdrErrors,ipInAddrErrors, ipForwDatagrams, ipInUnknownProtos, ipInDiscards, ipInDelivers, ipOutRequests,
ipOutDiscards, ipOutNoRoutes, ipReasmTimeout ,ipReasmReqds, ipReasmOKs,ipReasmFails,ipFragOKs,
ipFragFails, ipFragCreates
v The ipRouteTable OIDs are not implemented.
v The ipNetToMediaTable OIDs are not implemented.
v The icmp group OIDs are not implemented.
v The tcp group OIDs are not implemented.
v The udp group OIDs are not implemented.
v The snmp group OIDs are not implemented.
IBM systems - LAN printing technical support documents on the
world-wide-web
The following AS/400 iSeries ® documents and many others can be found by selecting the "Technical
databases" link at the System i Technical Support area of the IBM website.
32815, Configuring a *LAN 3812 SNMP Device Description
This document contains information on configuring *LAN 3812 SNMP device descriptions for LAN attached
ASCII printers. The term SNMP refers to Simple Network Management Protocol. SNMP allows for two-way
communication with the printer when attached to the LAN using a print server that also supports SNMP.
Support for the SNMP print driver is available in the base code for R450 IBM OS/400 and above, and is
being added to R430 and R440 OS/400 through PTFs. This is an alternative to using Remote Output
Queues (RMTOUTQs).
342 Programmer Manual