Buffer terminating conditions – Compuprint 4247-Z03 Programmer Manual User Manual
Page 58
0
Fast Draft (Model Z03 only)
1
DP
2
DP Text
3
NLQ
Buffer Terminating Conditions
The following controls cause buffered data to be released for printing:
v
Carriage Return
v
Line Feed
v
Reverse Line Feed
v
Form Feed
v
Horizontal Tab (if there is print head movement)
v
Vertical Tab
v
Backspace
v
Set 1/8 Inch Line Spacing
v
Set 7/72 Inch Line Spacing
v
Set Graphics Line Spacing
v
Select n/72 Inch Line Spacing
v
Invoke Text Line Spacing (if the line spacing is changed)
v
Relative Move Right
v
Relative Move Left
v
Relative Move Baseline
v
Shift In/Condensed Print
v
Shift Out/Double-Wide Print
v
Device Control 4/Cancel Double-Wide Print
v
Begin Subscript/Superscript
v
End Subscript/Superscript
v
Begin Double-Strike Print
v
End Double-Strike Print
v
Begin Emphasized Print
v
End Emphasized Print
v
Set Presentation Highlight
v
Continuous Overscore
v
Auto Underscore
v
Device Control 2/Select 10 CPI
v
Set 12 CPI
v
Proportional Space Mode
v
Change Font
v
Normal Density Bit Image Graphics
v
Dual Density Bit Image Graphics Type 1
v
Dual Density Bit Image Graphics Type 2
v
High Density Bit Image Graphics
v
Set Initial Conditions
v
Select Score Line (2381 and 4247 only)
v
Unidirectional Printing
v
Set Horizontal Margins
The following conditions also cause buffered data to be released for printing:
v
Parallel -INIT
v
Automatic Line Wrap
An automatic line wrap consists of a carriage return and line feed inserted after the maximum number of
characters has been printed on a line. The next character is then printed at the left margin on the
following line. Automatic line wrap occurs for text data but not for bit image graphics.
38
Programmer Manual