Compuprint 4247-Z03 Programmer Manual - Manual (Page 209)

07 Print bar code with both check digits generated by the printer and put at the end of the data. The
second check digit will be IBM Modulus 10. The first check digit will be IBM Modulus 11. Check
digit equals 11 minus remainder; check digit of 10 equals zero.
08 Print bar code with both check digits generated by the printer and put at the end of the data. The
second check digit will be IBM Modulus 10. The first check digit will be NCR Modulus 11. Check
digit equals 11 minus remainder; check digit of 10 equals error.
09 Print bar code with both check digits generated by the printer and put at the end of the data. The
second check digit will be IBM Modulus 10. The first check digit will be IBM Modulus 11. Check
digit equals 11 minus remainder; check digit of 10 equals error.
UPC Version A:
00 Generate check digit and print standard symbol. Variable data field of Write Bar Code command
contains 11 bytes, first the number system digit, then the 10 article number digits.
UPC Version E:
00 Print bar code; six digits are bar encoded. Ten variable data characters are input. From the ten
input digits, the printer generates both the check digit and the six bar code characters. The printer
does not bar code the check digit. The check digit only assigns odd or even parity to the six bar
encoded digits.
UPC Two Digit Add-On:
00 Print the two supplemental digits (bar/space pattern and HRI). The Write Bar Code command
variable data consists only of the two supplemental digits. The preceding Version A or E symbol
prints under control of separate Write Bar Code Control and Write Bar Code commands.
UPC Five Digit Add-On:
00 Print the five supplemental digits (bar/space pattern and HRI). The Write Bar Code command
variable data consists only of the supplemental digits. The preceding Version A or E symbol prints
under control of separate Write Bar Code Control and Write Bar Code commands.
EAN-8:
00 Print the bar code symbol. The input variable data is seven digits: two flag digits and five article
identification digits. The seven digits are all bar coded along with a check digit generated by the
printer. The check digit follows the last article identification digit.
EAN-13:
00 Print the bar code symbol. The input variable data is twelve digits — two flag digits and ten article
identification digits, in that order. The first flag digit is not bar encoded. The second flag digit, the
article identification digits, and a check digit generated by the printer are bar encoded. The first
flag digit prints in human readable form at the bottom of the left quiet zone. The first flag digit
governs the A/B number set pattern of the bar/space encoding of the six digits to the left of the
center pattern.
Two of Five Industrial, Two of Five Matrix, Two of Five Interleaved:
01 Print the bar code with no printer generated check digit.
02 Generate the check digit and print it with the bar code.
EAN Two Digit Add-On:
00 Print the two add-on digits (bar/space pattern and HRI). The Write Bar Code command variable
Chapter 4. IPDS Programming Information 189