Relative move baseline (esc j) – Compuprint 4247-Z03 Programmer Manual User Manual
Page 37
NN is the one-byte local font identifier number that specifies the font. The mapping of the local font
identifier is dependent upon the printer's emulation mode setting. In the Configuration Menu, if the
emulation mode is set to 4202 III XL, the Change Font control code selects fonts compatible with the 4202
Proprinter III XL Printer. If the emulation mode is set to 4247 or 2381, Change Font selects the fonts
compatible with the 2381 Personal Printer.
Supported local font identifiers are shown in the following table.
Local Font
Identifier
(Hex)
4247 and 2381 Emulation Mode
4202 III XL Emulation Mode
00
Default (op. panel selection)
DP
01
DP
Fast Draft (for model Z03); DP (for model X03)
(See Note 1)
02
DP Text
DP Text
03
NLQ (Courier/Gothic)
NLQ (Courier/Gothic)
04
DP Text Proportional
DP (Download)
05
NLQ Proportional (Courier/Gothic)
DP (Download)
06
Fast Draft (for model Z03); DP (for model X03)
DP text (Download)
07
Reserved
NLQ (Download)
08-0F
Reserved
Reserved
10
OCR-A
Reserved
11
OCR-B
Reserved
12-5F
Reserved
Reserved
60
Reserved
Default (op. panel selection)
61
Reserved
Fast Draft (for model Z03); DP-Gothic (for model
X03) (See Note 1)
62
Reserved
NLQ Proportional (Courier/Gothic)
63
Reserved
OCR-A
64
Reserved
OCR-B
65
Reserved
Fast Draft (for model Z03); DP (for model X03)
(See Note 1)
66-FF
Reserved
Reserved
Notes:
1. If printer configuration Host Fast Draft setting is Enabled, then Fast Draft quality is selected. If Host
Fast Draft is disabled then DP quality is selected (only for model Z03).
2. If a downloaded font has not been previously downloaded with a Character Font Image Download
control (CFID), a Change Font control to select a downloaded font is ignored.
3. The NLQ font style is selected as defined in the Configuration Menu as either Courier or Gothic.
Relative Move Baseline (ESC J)
1B
4A
NN
This control performs a vertical move relative to the current print position.
Chapter 1. Personal Printer Data Stream (PPDS)
17