Set 7/72 inch line spacing (esc 1), Set 1/6 inch line spacing (esc 2), Set n/216 inch line spacing (esc 3) – Compuprint 4247-Z03 Programmer Manual User Manual
Page 72: Select italic mode (esc 4), Cancel italic mode (esc 5), Set n /216 inch line spacing (esc 3)
The application program is responsible for keeping track of the vertical position on the current page
relative to the current line spacing. Changing the line spacing within a print job without changing the page
length can cause printing on the page perforation. For additional information, see “Set Page Length (ESC
C)” on page 55.
Set 7/72 Inch Line Spacing (ESC 1)
1B
31
This control sets the line spacing to 7/72 inch.
The application program is responsible for keeping track of the vertical position on the current page
relative to the current line spacing. Changing the line spacing within a print job without changing the page
length can cause printing on the page perforation. For additional information, see “Set Page Length (ESC
C)” on page 55.
Set 1/6 Inch Line Spacing (ESC 2)
1B
32
This control sets the line spacing at the value set by the last Set Text Line Spacing (ESC A) control
received. The printer sets the line spacing to six lines per inch if no ESC A has been issued.
Set n/216 Inch Line Spacing (ESC 3)
1B
33
NN
This control changes the line spacing to the value specified by NN.
NN is a value that specifies the line spacing in units of 1/216 inch. Valid values are 0 to 255. If NN equals
0, the printer ignores this control.
The application program is responsible for keeping track of the vertical position on the current page
relative to the current line spacing. Changing the line spacing within a print job without changing the page
length can cause printing on the page perforation. For additional information, see “Set Page Length (ESC
C)” on page 55.
Select Italic Mode (ESC 4)
1B
34
This control turns on italic character printing. This control is valid even if the Epson Extended Graphics
character set has been selected by the Character Table (ESC t) or the operator panel, but character
graphics cannot be italicized. This control is used in both DP and NLQ.
Cancel Italic Mode (ESC 5)
1B
35
NN
This control cancels italic character printing.
52
Programmer Manual