Specification check-general - x'02 – Compuprint 4247-Z03 Programmer Manual User Manual
Page 224
X'03D102'
Graphic Image Format Not Supported
Explanation: The value specified for the graphic
image format parameter is not supported.
Alternate Exception Action: None.
X'03D103'
Image Width Greater Than Maximum
Supported
Explanation: The Width value specified in the Begin
Image order exceeds the maximum image width
supported by the product.
Alternate Exception Action: The image width is
truncated at the maximum width supported.
X'03D104'
Image Height Greater Than Maximum
Supported
Explanation: The Height value specified in the Begin
Image order exceeds the maximum image height
supported by the product.
Alternate Exception Action: The image height is
truncated at the maximum height supported.
X'03E100'
Relative Line Outside Coordinate
Space
Explanation: The relative line starts inside the drawing
order coordinate space but goes outside.
Alternate Exception Action: None.
Specification Check-General - X'02'
The following exception codes are the valid codes for a general specification check condition:
X'020001'
Embedded Text Control Code Error
Explanation: Undefined text control code.
Alternate Exception Action: Ignore the control
sequence.
X'020201'
End Suppression Text Control Error
Explanation: The active Begin Suppression ID within
the current page, overlay, or page segment is not the
same as that specified in the ES control.
There is no active suppression ID.
X'020202'
Invalid IPDS Command Length
Explanation: The length for a command is not within
the allowed range.
The length of a Request Resource List entry is not a
valid or supported value.
The length specified for a Request Resource List entry
does not match the number of bytes received.
Alternate Exception Action: None.
X'020205'
Invalid Data Structured Field Length
Explanation: A data structured field has been received
in a WGC or WBCC command that is less than the
minimum allowable length.
Alternate Exception Action: None.
X'020302'
IPDS Command Header Length too
Small
Explanation: The length value of a command is less
than 5 (or less than 7 if a correlation ID is included).
Alternate Exception Action: None.
X'020305'
Area Position Orientation is Not
Supported
Explanation: The orientation specified in the Area
Position structured field of the WGC or WBCC
command is not a valid or supported value.
Alternate Exception Action: None.
X'020401'
End Page Encountered During Active
Suppression
Explanation: The End Page control was encountered
before a text suppression ended.
Alternate Exception Action: Process the object as if
the corresponding End Suppression control sequence
appeared at the end of the object. That is, all of the
data following the Begin Suppression control sequence
in the object is processed and suppressed.
X'020402'
Acknowledge Reply Response
Continuation Request is Invalid
Explanation: The printer received a command whose
response continuation bit is on but there is no response
to continue.
Alternate Exception Action: None.
X'020405'
Area Position Reference System is Not
Supported
Explanation: The reference system specified in the
Area Position structured field of the WGC or WBCC
204
Programmer Manual