AMETEK CTS 3.0 - Manual (Page 88)

Compliance Test System 3.0 User Manual
84
6.4 Running a Flicker Test
Running a flicker test is similar to running a harmonics test. Launch CTS 3.0 and select flicker
test in the set up screen. Then select appropriate test parameters and click OK to continue. You
will be presented with a test screen similar to that of harmonics.
The flicker test window has several user accessible fields and controls. The following table briefly
describes the purpose of each field and control.
Figure 6-1: Flicker Test Window
Test Start
and Stop
Enter test
margin
here