AMETEK CTS 3.0 - Manual (Page 69)

User Manual Compliance Test System 3.0
65
4.5 View Menu
The View menu offers the following sub-menu choices.
SUB MENU DESCRIPTION
Test Setup Brings up a overview of all selected test setting for the current test. This is a
display window only and no fields can be changed in this mode. To change
setup option, close the active test window and select Perform a new Test
from the Test menu.
Test List Brings up a display grid showing all tests ran to date on the test system PC.
For each test, a time stamp, test type and pass fail result is shown. Any test
for which data was recorded can be played back by selecting it and clicking
on the replay button at the bottom of the screen.
Calibration Info Displays a summary window of the Card serial number, PACS serial number,
frequency calibration and last calibration date.
4.6 Options Menu
The Options menu offers the following sub-menu choices.
SUB MENU DESCRIPTION
Get a new reference for
each test For Harmonics tests with a limit set that is a function of the power level or
current of the EUT, a new reference can be established for each test run.
Alternatively, the last used reference can be preserved for subsequent test.
This menu entry toggle between these two available modes.
Generate ASCII Files at
the end of test When selected, this option causes tab delimited ASCII files to be generated
at the end of the test from the binary data files recorded during the test run.
ASCII files take up more space but can be opened using other application
programs. All the ASCII files will be in the sub directory “ASCII_files”.
Please note that even if this item is not selected, conversion from a binary
test file to ASCII files can also be accomplished using the ASCII converter
program (Convert data to ASCII) supplied as part of the CTS 3.0 program
suite.
Show Banner at the end
of test When selected, this option causes a large banner (Green when PASS, Red
when FAIL) to appear on the screen of the PC. This banner can be seen
from across the room to notify a lab operator that the test run has been
completed.
Recall Type Valid for data replay only. This option offers four choices for playback of
data. Data is stored in acquisition windows or buffers. For Harmonics,
acquisition windows are either 10, 12 or 16 cycles. For Flicker, acquisition
windows are 1 second. Available recall choices are:
Every Window: Every acquisition window is shown
Every
failed/distorted
Window Only acquisition windows with current failure or
distorted source are shown.
Every Failed Source
Window Only acquisition windows with high AC source
distortion are shown.
Every Failed Current
Window Only acquisition windows with current failure are
shown.