AMETEK CTS 3.0 - Manual (Page 51)

User Manual Compliance Test System 3.0
47
The new data acquisition card will appear as a node in the LocalSystem | Hardware | Exacq |
PCI/PXI branch of the System tree.
Click on this node. The serial number and logical device number will display in the Configuration
pane. The logical device number is the identification that application software such as the CTS
uses to specify which hardware device will be used. This device number should only be changed if
you have multiple A/D cards in the PC. See
Figure 3-13 below).
Otherwise, leave the number as is. In the event this is necessary, you may change the assigned
device number by clicking on the configuration tab and selecting a new number using the device
number edit control. Only knowledgeable users should make changes to these settings.
Figure 3-13: Exacq Card Device Number