AMETEK CTS 3.0 - Manual (Page 58)

Compliance Test System 3.0 User Manual
54
JP11 JP13
1 1
Address DIP
Normal Mode
(Factory Setting)
Diff. Mode
JP11 JP11
1
1
4 4
Pin 19 = DAC Pin 19 = Ground
(Factory Setting)
JP13 JP13
1 1
3 3
Jumper JP11
Jumper JP11 selects between differential or single ended input channel mode and should be set
to single ended mode for the CTS system. The correct setting is shown in Figure 3-20. Pin 1 and
2 are jumpered together as are pins 3 and 4. This is the setting in which the board is shipped
from the factory and you should not have to change it.
Jumper JP13
Figure 3-20: A/D Card JMP 11 Settings
Figure 3-21: A/D Card JMP 13 Settings