Delta Electronics AC Motor Drive VFD-G - Manual (Page 76)

Chapter 4 Parameters|
Revision July 2008, EG03, SW V1.06 4-25
Bit 8: Master frequency source via communication interface
Bit 9: Master frequency source via analog
Bit10: Running command via communication interface
Bit11: Parameter locked
Bit12~15: Reserved
00 - 03 Frequency Setting (F) or Closed Loop Control Setting Point
Factory setting: Read Only
This parameter displays the frequency command set by the user.
00 - 04 Output Frequency (H)
Factory setting: Read Only
This parameter displays actual output frequency of the AC drive.
00 - 05 Output Current (A)
Factory setting: Read Only
This parameter displays actual output current of the AC drive.
00 - 06 DC-BUS Voltage (U)
Factory setting: Read Only
This parameter displays DC-BUS voltage of the AC drive.
00 - 07 Output Voltage (E)
Factory setting: Read Only
This parameter displays output voltage of the AC drive.
00 - 08 Output Power Factor (n)
Factory setting: Read Only
This parameter displays output power factor.
00 - 09 Output Power (kW)
Factory setting: Read Only
This parameter displays output power of the AC drive.