Echelon IzoT Commissioning Tool - Manual (Page 56)

or have dynamic IP addresses that do not change. A static IP address is an address that is not
dynamically assigned by a DHCP server.
2. Create an IP-852 interface on each computer that is to be connected to the IP-852 channel. This
may include the OpenLNS Server computer and one or more IzoT Commissioning Tool
computers. To create an IP-852 interface, follow these steps on each of the computers:
a. Open the L ON W ORKS Interfaces application in the Control Panel.
b. Click the IP-852 tab.
c. Click Interface, point to Add, and then either click IP-852 Interface or click New Interface
and then click IP-852 in the Select Interface Type dialog.
d. The Add Network Interface Wizard dialog opens.
e. Specify the name of the new IP-852 network interface; the IP address, port, and channel
timing parameters; and authentication parameters. Click OK.
For more information on creating IP-852 network interfaces, see the L ON W ORKS Interfaces
online help file.
3. Define the IP-852 channel and devices in the IP-852 Configuration Server. To do this, follow
these steps:
a. Click Start on the taskbar, point to Programs, point to Echelon IP-852 Configuration
Server, and then click Echelon IP-852 Configuration Server.
b. Click Channel, and then click New Channel. Enter a name for the new IP-852 channel.
c. Right-click the new IP-852 channel you just created and then click New Device. Enter a
name for the new device.
d. Right-click the new device and then click Device Properties. Enter the IP address for the
device.
e. Repeat steps c and d for each OpenLNS Server computer, IzoT Commissioning Tool
computer, and IP-852 router on the IP-852 channel.
40 Getting Started