Echelon IzoT Commissioning Tool - Manual (Page 121)

Name Select the two channels that you will attach to the router. You can
enter a new channel name for one or both of the channels to add new
channel SmartShapes to your OpenLNS CT drawing.
The channel names must be unique within the network and be no
more than 85 characters long. If you are creating one or two new
channels, specify the channel type for each channel in the Type box.
3. Click Next. The Router Properties window opens.
4. Enter the following information:
Location Specifies the 6-byte location string for the router, which
documents the router’s location within the network.
To store the router’s subsystem ID in this field, follow these
steps:
3. Click Add-ins, point to IzoT Commissioning Tool, and
then click OpenLNS Options. Select Recovery from the
options category list and then select the
Set Location
Property to Subsystem ID check box under Subsystem
Recovery Options.
4. Resynchronize the network. When you resynchronize the
network, select the Update Location Path and ID in
Devices check box in the Synchronize OpenLNS CT
Drawing dialog. The router’s current subsystem ID will be
stored in this field. The IzoT Commissioning Tool tool can
then use this information to place devices in their correct
subsystems in the event you need to use the OpenLNS
database Recovery Wizard to recover a lost network
database.
See Recovering an IzoT Commissioning Tool Network in
Chapter 7, Maintaining Networks, for more information on
IzoT Commissioning Tool User’s Guide 105