Nortel Networks T7316 - Manual (Page 56)

56 Chapter 4 Time-saving features
P0937240 03.1
Use intercom as the line for Autodial
If you press an intercom button as the line for an external autodial number, you must include a
valid line pool access code or a destination code. If access codes for line pool or destination codes
change, remember to reprogram autodial numbers.
These are some of the prompts you might receive:
Continue to enter digits until the number is complete. Press √
or BKSP to erase an incorrect digit.
Press ≥ or OK when you finish.
The memory allocated to autodial numbers in your system is full.
While programming external Autodial, you erased the button by
pressing ≥ or OK before entering any digits.
Enter the number you want to program, selecting the line first if
necessary, exactly as if you were making a call.
Enter the internal telephone number you want to program.
You are programming an internal autodial button and have entered a
number that is not an internal number on your system. Enter a valid
internal number. If the number you are entering is a destination code,
use external autodial.
Press the memory button you want to program.
Enter the number you want to program on the button, then press ≥.
Enter the number you want to program on the button, then press ≥ or
OK. You can include a line or line pool selection in an autodial sequence
by selecting the line before entering any digits.
The number is correctly stored on the button.
For other displays, see Appendix B, “Common display prompts and error messages,” on page
167 .
987___
QUIT BKSPOK
Autodial full
Button erased
Enter digits
QUIT OK
Intercom #: ___
QUIT
Invalid number
Press a button
QUIT
Program and HOLD
Program and OK
QUIT OK
Programmed