Nortel Networks T7316 - Manual (Page 55)

55
Telephone Features Programming Guide
Chapter 4
Time-saving features
This chapter shows you how to use some time-saving features, such as:
• Autodial
• Last Number Redial
• Speed Dial
• Saved Number Redial
Autodial
You can program memory buttons for one-touch dialing of internal or external telephone numbers.
You cannot use buttons for lines, answer or Handsfree/Mute as autodial buttons.
If the power to your Business Communications Manager system is off for more than three days,
autodial numbers and some other system programming can be lost from the memory.
To add an autodial button:
1 Press ≤•⁄ to program an external number or ≤•¤ to program an internal
number.
2 Select a memory button.
3 Dial the number.
When programming Autodial you can use the following features:
• Last Number Redial
• Saved Number Redial
• destination codes (select an intercom button as the line)
Select a line for Autodial
To select a line for an external number, press the line or intercom button before you enter the
number. To select a line pool, press a programmed line pool button, or press an intercom button,
and enter a line pool access code.
If you select a line before pressing the autodial button, the call goes out on that line instead of the
line that is part of the autodialer programming.
For the T7100 and NetVision telephones, program an external autodialer by using a line and not a
line pool.
Note: If you do not include a line selection in an autodial number, the call uses your
prime line (if you have one).