Customize your cap(n) module, Figure 9, Cap module with m7324 and m7324n telephones – Nortel Networks T7316 User Manual
Page 38
38
Chapter 2 Answering calls
P0937240 03.1
Figure 9
CAP module with M7324 and M7324N telephones
Customize your CAP(N) module
When a CAP(N) module is first plugged into your telephone, some of the module buttons are
automatically programmed to dial an internal number. You can program any of the buttons on your
CAP(N) module that do not select lines to dial internal or external numbers automatically.
If your installer has programmed the CAP(N) module for your system, you can move external lines
to the CAP(N) module by using
≤•°⁄. See
“Move line buttons” on page 108
You can program features on CAP (N) module buttons. See
Chapter 4, “Time-saving features,” on
and
Chapter 9, “Customize your telephone,” on page 99
for information about
programming memory buttons. You cannot assign any buttons on a CAP(N) module as answer
buttons.
Note:
Under certain circumstances of system recovery, where the system administrator
runs a backup/cold start/restore procedure, the CAP may only restore line assignments to
the M7324(N) part of the station. In this case the CAP(N) lines are assigned to buttons on
the M7324(N) telephone, overwriting any existing programming on those buttons. Any
lines that cannot be assigned to buttons, will simply ring. If you experience this problem
after system recovery or maintenance, notify your system administrator.
CAPN Module
M7324N telephone
M7324 telephone
CAP Module