Making calls, Making a second call, Receiving calls – Nortel Networks T7316 User Manual
Page 151: Handling two calls, Releasing calls, Releasing a single call
Chapter 14 Cordless telephones and features
151
Telephone Features Programming Guide
Making calls
Making calls from your handset is similar to other wireless handsets (cell phones).
•
internal calls: enter DN
•
external calls: enter line pool code or destination code plus the required call numbers.
The route accessed by the destination code may also contain all dialout digits except the target
DN. Your system administrator can provide you with the correct digits that you need to dial for
an external call, which includes calls made over a private network.
Making a second call
If you want to make a call from a telephone that has an active call:
1
Press .
2
Enter
Receiving calls
•
From an idle set, press
•
On an active set with an active call, in response to the call waiting tone: Press
Handling two calls
To move between two active calls, press
to put the current call on Hold, and to activate the
held call.
Releasing calls
How your handset acts when you release a call depends on whether there was one or two calls
currently on the handset.
Releasing a single call
If there is only one call present on the handset, press
.
Note:
The handset will not go offhook unless you enter at least one digit before you press
the
key.
SND
SND
SND
SND
HOLD
HOLD
SND
SND
SND
SND
HOLD
HOLD
HOLD
HOLD
END
END