Nortel Networks T7316 - Manual (Page 48)

48 Chapter 3 Make a call
P0937240 03.1
Program a line pool feature code
When you program a button with the line pool feature code (≤fl›), you must enter a line
pool access code after the feature code. The programmed line pool button accesses a specific line
pool, not the line pool feature. See
“Programming feature codes” on page 101 for more
information.
If you program a button with an indicator to access a line pool, the indicator for the line pool
button turns on when all the lines in a line pool are busy. The indicator turns off when a line
becomes available.
Line buttons
There is one line button for each line assigned to your telephone. Press the line button to select the
line you want to use to make a call.
The T7100(N) and NetVision telephones have two intercom paths, instead of line buttons, to
answer and make calls. You can press ≥ to switch between two calls, one active and one on
hold.
Select how you dial your calls
To select a dialing mode:
1 Press ≤•°¤.
2 Press £ or NEXT until the dialing mode you want appears.
3 Press ≤ or OK to select the dialing mode.
You cannot program the dialing modes feature code on a memory button.
Standard dial
Standard dial allows you to make a call by selecting a line and dialing the number. If you have a
prime line, it is selected automatically when you lift the handset or press the handsfree button.
You cannot use Standard dial on a T7100 telephone unless you pick up the handset first.
• If you have a T7100 telephone, use the Automatic dial or Pre-dial feature for on-hook dialing.
• NetVision telephones only allow you to use pre-dial. To make a call, dial the number, and then
press
. SND SND