KEYENCE IL Series - Manual (Page 28)

2-8 IL-E
2
Installation and C
onnection
2-2
Connecting and Mounting the Sensor Head
Attach the sensor head using the dedicated mounting bracket.
When the dedicated bracket is not used, place the included insulation sheet between the
mounting surface and the sensor head as indicated in the diagram. (When the dedicated
bracket is used, or when the IL-2000 is used, the insulation sheet is unnecessary.)
Mounting the Sensor Head
Point
The optical axis may vary by approximately ±1.5° (IL-S025/IL-S065/
IL-2000), or ±2.0° (IL-030/IL-065/IL-100/IL-300/IL-600).
z Mounting when detecting targets
close to a wall
z Mounting when detecting targets in
a hole
z When detecting uneven workpieces
Insulating sheet
Sensor head
Screws included
with the head
Intelligent-L
AVOID E
XPOSURE
LASER RADI
ATIO N IS EMIT
TED
FROM THIS A
PERT URE
IL-030
Tightening torque:
1.2 Nm (12kgf•cm) or less
(IL-S025/IL-030/IL-S065/IL-065/
IL-100)
2.7 Nm (27kgf•cm) or less
(IL-300/IL-600)
3.0 Nm (30kgf•cm) or less
(IL-2000)
• The stray
reflections
from the wall
have little
effect.
• Variations in
the detection
value are
possible due
to stray laser
light.
• The target
cannot be
detected when
the transmitter or
receiver is
blocked.
• Stable
detection
even on
uneven
areas.
• Incorrect values
can be detected
on uneven
areas.