KEYENCE IL Series - Manual (Page 135)

A-9
Append
ix
IL-E
3
Factory Setting (Default Value) List
This section describes the factory settings (default values).
If the initial reset is performed, the default values will be restored as below except for the
calibration function.
“Initial Reset (Initialize)” (page 3-8)
Values set on the main screen
The bank 0 to 3 have the same value.
Basic Settings and Advanced Settings
Other functions
The values for the IL300/600 are written in parentheses. The values for the IL-2000 are
written in double parentheses.
Setting items Default value
HIGH side setting value 5.000 (50.00)((500.0))
LOW side setting value -5.000 (-50.00)((-500.0))
Shift target value 0.000 (0.00)((0.0))
Setting items Default value Description
1. Measurement direction nor
The display value increments when the object
approaches the sensor head.
2. Sampling rate dEFLt Default setting
3. Averaging rate, Step count filter,
High-pass filter
16 Averaging:16
4. Alarm setting dEFLt Default setting
5. Output state no Normally Open
6. Hold function 5-H Sample hold
7. Timing input LeveL Level
8. Delay timer off The delay timer is not used.
9. Hysteresis
0.000
(0.00)((0.0))
0.000 mm (0.00 mm)((0.0 mm))
10. Analog output scaling defLt Default setting
11. External Input defLt Default setting
12. Bank switching method btn Button operation
13. Zero shift value memory function M-off Not save on the nonvolatile memory (EEPROM)
14. Interference prevention function off Mutual-interference prevention function OFF
15. Display digit dEFLt Default setting
16. Power saving function off Not display the power saving (Normally ON)
17. Head display mode defLt Normal
18. Display color GoGrn GO green
Setting items Default value Description
Calculation Function off The calculation function is not used.
Calibration Function defLt Default setting
Calculation calibration function defLt Default setting
Tolerance for tolerance tuning
0.200
(2.00)((20.0))
0.200 mm (2.00 mm)((20.0 mm))